- Alpha 4 metering Gatekeepers with EnergyAxis mesh and Cat-M1 connectivity
- Battery-powered gas/water communication module firmware 2.1 supported
- Beltclip Radio firmware 1.5 supported
- NXCM R200 firmware 2.0 supported
- Fixed LANID/Serial Number sync issue for EnergyAxis meters
- Fixed an issue where Inspector running on Android 6.0.1 couldn’t sync with Metercat Server
NOTE: this version requires Metercat Administration Station 8.4 when using with NXCM gas modules.
Inspector is an Android app designed to communicate with Honeywell meters via RF interface (for meters connected to EnergyAxis or SynergyNet 900 MHz mesh network).
To communicate to meters, the Inspector app uses a BeltClip radio module as RF gateway. The BeltClip module communicates to the Inspector app using Bluetooth and to the meters over 900 MHz mesh network (EnergyAxis or SynergyNet).
Inspector allows performing RF troubleshooting, reading, service and configuration operations. Example of RF troubleshooting operations are testing RF connectivity of the meters, locating nodes in range, and reporting RF signal strength.
Using Inspector, a field service personnel can:
Connect to a Metercat Server to receive settings and data that has been authorized by a system administrator for the specific user.
Execute meter functions (for example, ping node, locate registered nodes, read meters) as configured and authorized by a system administrator.
Connect to a Metercat Server to remotely and securely transmit the meter readings performed in the field.